Rancang Bangun Kontroler Logika Fuzzy Untuk SEPIC Pada Pengisian Baterai Lead Acid Berbasis SIMULINK

Safa Aulia Zerlina, Era Purwanto, Indra Ferdiansyah

Abstract


Single Ended Primary Inductace Converter (SEPIC) merupakan konverter turunan buck-boost converter di mana konverter tersebut dapat menaikkan maupun menurunkan tegangan input namun polaritas tegangan output SEPIC tidak berubah. Di mana polaritas tegangan output buck-boost converter terbalik. Salah satu pengaplikasian SEPIC adalah pada sistem pengisian baterai Lead-Acid 48 volt 45 AH. Hasil simulasi gelombang pada software MATLAB saat kondisi pengisian open-loop masih terdapat ripple di dalamnya. Kontrol yang digunakan saat sistem charging close-loop merupakan kontrol Fuzzy Logic dengan metode yang digunakan adalah metode Mamdani. Hasil yang didapatkan adalah nilai error pada tegangan output sistem close-loop dengan kontrol fuzzy yang lebih kecil yaitu 1, 05 % dari respon kontrol PI dengan error pada tegangan output sebesar 1,56 % dan waktu yang diperlukan untuk mencapai steady state pada sistem dengan kontrol fuzzy lebih singkat sebesar 0,012 detik daripada dengan menggunakan kontrol PI dengan waktu sebesar 0,026 detik


Keywords


SEPIC; converter; baterai lead-acid; kontrol logika fuzzy

Full Text:

PDF

References


D. W. Hart, Power Electronics, New York: McGraw-Hill: 2010.

Ganesh, S., Janani, J., & Angel, B.G. A Maximum Power Point Tracker for PV Panels Using SEPIC Converter, International Journal Electric and Computer Engineering, Electronic Communication Engineering. 2014; 8(2): 356-361.

Mahendran, G., & Kandaswamy, K.V. Ant Colony Optimized Tuned DC-DC Converter, International Conference on Innovations In Intelligent Instrumentation, Optimization And Signal Processing “ICIIIOSP-2013â€. Coimbatore. 2013; 16-21.

Baliwant, B. B., Gothane, A. R., & Waghmare, P. V. B. PWM Based Charge Controller for Renewable Energy Aplications Using SPIC Converter. 3rd International Conference on Computing Methodoligies and Communication (ICCMC), 2019; 1051-1054.

Rose, J. L., & Sankaragomathi, B. Design, Modeling, Analysis and Simulation of a SEPIC Converter. Middle-East Journal of Scientific Reasearch. 2016; 24(7): 2302-2308,

Oudda, M., & Hazzab, A. Fuzzy Logic Control of a SEPIC Converter for a Photovoltaic System. Journal of Fundamentals of Renewable Energy and Applications. 2016; 6(4): 1-7.

Khateb, H.E., Rahim, N.A., & Selvaraj, J. Fuzzy Logic Control Approach of a Maximum Power Point Employing SEPIC Converter for Standalone Photovoltaic System. IEEE Transactions on Industry Applications. 2014; 50(4): 2349-2358.

Dunia, J., & Mwinyiwiwa B.M.M. Performance Comparison between CUK and SEPIC Converters for Maximum Power Poinr Tracking Using Incremental Conductance Technique in Solar Power Applications. International Scholarly and Scientific Research & Innovation. 2013; 7(12): 1638-1643.

Patil, M. S., & Patil, S. P. Single-Phase Buck-Type P ower Factor Corrector with Lower Harmonic Contents in Compliance with IEC 61000-3-2. International Journal of Engineering Science and Technology. 2010; 2(11): 6122-6130.

Sangeetha, M., Kiruthika, S., Priyadharshini R., & Divya, K. Power Factor Correction Using DC-DC SEPIC Cinverter Optimized With Fuzzy Logic Controller. International Journal of Innovative Research in Science Engineering and Technology. 2019; 8(3): 2502-2514.

Boutuba, M., Elougli, M., Miqoi S., & Tidhaf, B. Design and Experimentation of a Control System Implemented on Raspberry Pi 3 Board for Photovoltaic System Using SEPIC Converter. Journal of Electrical System. 2017; 13(4): 661-677.




DOI: https://doi.org/10.35314/ise.v3i3.2263

Refbacks

  • There are currently no refbacks.


Copyright (c) 2021 INOVTEK - Seri Elektro

View My Stats